Remove the ejector bushing and spring from the ejector/ratchet piece.Ħ. CAUTION: The spring is under compression and the removal of the pin will release both the ejector rod at the front and the ejector bushing at the rear.Įase them out, and take care not to lose the tiny bushing pin.ĥ.
Use a drift punch to push out the small cross pin. Remove the knob,spring and sleeve towards the front.Ĥ.Depress the rear tip of the ejector rod and turn the rod until it's internal pin aligns with the cross-hole in the ejector/ratchet piece. Use smooth jawed pliers to grip the ejector rod near the crane and unscrew the ejector knob (it dosen't say if it is a right or left hand thread S&W are left hand) Operate the cylinder Latch,swing the cylinder out, and remove the cylinder and crane assembly towards the left.ģ. Remove the crane screw, taking care not to lose the nylon lock washer.Ģ. The crane retaining screw is located at the lower front of the frame.
but that is the only one in my book on assembly/disassembly.ġ.
0 kommentar(er)
